Information Warning Regarding figma Saber 2.0
figma Saber 2.0 was shipped out on the 15th January 2015, and we would like to warn our customers regarding the protective plastic around the waist joint. You will notice there is some protective vinyl plastic around the waist joint as seen here:
To remove this plastic, please ensure you do not disconnect the waist joint. The joint is a special joint made for the 2.0 design, and is not intended to be disconnected. Instead, simply pull at the plastic quite hard. The plastic piece should pull out like so:
We highly recommend not removing the joint in order to remove this plastic.
Should you have any further questions, please contact the support team below.
Web Form: https://partner.goodsmile.info/support/en/inquiry/